#SYSTEM CONTROL INTERFACE V2 DRIVERS#
#SYSTEM CONTROL INTERFACE V2 MANUAL#

G3 Gimbal V2.1 must be used with APS-M V2.

Aerodynamically, FS One V2 is unsurpassed for ultimate realism in flight simulation and fun Highly Accurate Aerodynamics. It is based on decades of experience flying and simulating model aircraft in all categories: trainers, sport planes, jets, warbirds, foamies, sailplanes and helicopters. Provide support for modeling a diverse set of system logical and physical interfaces, including electrical, mechanical, software, and operator interfaces, as well as supporting interface modeling paradigms such as those used by Modelica.

G3 Gimbal V2.2 must be used with APS-M V2.1 FS One V2 is designed to be the most accurate simulation of RC flight.

Systems on the rail control system network will be providers of data and control functions.

Tilt travel angle can be adjusted through program interface (90 to 120 degrees). The rail control system network (RCSNET) is the bottom layer of the network it contains metro signal control (MSC) systems such as rail control systems that manage the movement of trains on the rail network.

#SYSTEM CONTROL INTERFACE V2 MANUAL#

Enabled manual control for follow mode.Added gimbal offset adjustment for all 3 axis.Added reset to factory default values function in interface program.

#SYSTEM CONTROL INTERFACE V2 DRIVERS#

Program interface automatically recognizes G2/G3 gimbal type without manual selection. This application keeps your system up-to-date, identifying new drivers available for your Intel components.Adjustments for Pan and Roll are rolled into advanced settings which does not need adjustment for basic function. Pilot only need to adjust the P gain, D gain, and Power for Tilt axis. Consolidated gimbal parameter adjustment method.For gimbal control with single RC transmitter of 8 channels or more, with enough channels available from the RC transmitter, each of the function can be configured to channel 9~14 through APS-M program interface: pan, tilt, roll, shutter trigger, return to center, panoramic photo.If there is any irregular Gimbal performance happened, just simply point down Gimbal TILT or switch on вЂњNeutral Point CalibrationвЂќ then the gimbal can automatically neutralize back to the center by itself.If any abnormalities affects the gimbal initialization, or PAN axis experiences abnormal compensation due to external forces, gimbal will automatically re-initialize and return to center.After completing the setup the gimbal will automatically revert back to follow mode. This is done to facilitate the ease of setting gimbal parameters. When gimbal is connected, PAN axis will automatically be set to lock mode if itвЂ™s in follow mode.Added option to activate/disable the 6 control functions of gimbal.Cancel G3 Roll Follow function whereas вЂњFollowвЂќ icon still leave on the interface but not allowed to be activated.Correct Panoramic Mode shooting angle and quantity to 0, 2, 4, 6, 8, 10.

System control interface v2